COLD Rads or Dirty Water when                 Loud Irritating Noises or Boiler
                      Bleeding                                                         Cuts Out

                               
                                                                                    The objective of Power Flushing is to restore systems with circulation and boiler noise problems (caused by sludge and corrosion deposits) to optimum operation. Power flushing removes these deposits and the problems that they cause.

Power Flushing is also an excellent way to pre-commission clean new heating systems, to remove excess flux, swarf and other debris, and the grease and oil used to prevent rusting of components before use.

It is prudent to Power Flush a heating system immediately before fitting a new boiler to an existing system to prevent possible future problems. If you do not Power Flush exsisting pipework and radiators before installing a new Boiler and then you have problems with your new boiler, you will find the warranty will be void. 

Many systems are found to contain corrosion and sludge, even if no flow problems have yet shown themselves. Existing debris is often mobilised by alterations to the system/piping and the increased efficiency of the new boiler, and may then accumulate in the boiler heat exchanger, causing noisy operation, reduced efficiency and, in extreme circumstances, failure of the boiler. The high efficiency and compactness of modern boilers, developed to minimise fuel costs and pollution, means that they are more susceptible to problems caused by debris in the system water.

     Area's of Home COLD                    Top Of Rads COLD                                                

                      Hot Water NOT very hot or on a Combi

                                   it Fluctuates between HOT & COLD

                 Need Power Flushing 07961833820